Citronic CDUSB-2 User Manual

Page 5

Advertising
background image

170.663UK User Manual


Display









36. CD - USB - SD

Current selected audio source

37. Track number

Current selected track or total number of tracks when first loaded

38. Play - Pause - Skip

Current play status (play, pause, forward or reverse symbol)

39. Elapsed - Total - Remain Time display status (elapsed, total elapsed or remaining time)
40. Time

Minutes, seconds and hundredths display

41. Progress

Bar graph display showing track progress - flashes 30s before end

42. BPM

Beats per minute display

43. Folder

Current selected folder or total number of folders when first loaded

44. Cue

Indicates when track is at cue point & flashes when cue point is set

45. Single - Continue

Single track play or continuous folder play

46. Loop

Indicates when loop is active

47. Pitch

Displays percentage of playback speed when pitch change is active

48. ID3 display

Track name (scrolling) display


Operation

Connect the fig.8 inlet (28) to a mains supply using the mains lead supplied and connect the audio
output (29) to the mixer, recorder or amplifier being used. Press in the power button (1) to power up
the unit.


To play a CD, press the “Open/Close” button (13) and a drawer will eject from the front panel.
Carefully place the CD with print-side-up onto the drawer and press “Open/Close” again to load.


When loaded, if CD is not selected, press Source select (4) until “CD” is displayed as the source.
Disc information will be displayed. Standard CD audio or compressed digital audio can be played.
Press Play/Pause to initiate playback.


To play compressed audio files from a USB memory device or SD card, insert the media into the
relevant connector on the front panel (11, 12) and press Source select to choose the relevant media.


Press Play/Pause to initiate playback and use further controls as detailed in the panel layouts above.

The CDUSB-2 can be operated either by front panel controls or the supplied handheld IR remote
control. Before use, insert the 2 x AAA batteries into the remote control, observing the correct
polarity as indicated inside the rear compartment.

Advertising