Dynon Avionics Servo Datasheet / Generic Servo Kit (Push-Pull) - Manual (Page 7)

DYNON AVIONICS
Servo Mounting Instructions – Generic Push-Pull Kit 6
101046-000 Rev E
Linkage mount position force and travel
The two diagrams below illustrate the maximum travel and force available at each linkage mounting
point. As can be seen, the closer you mount the linkage to the shaft, the more force the servo can
deliver. However, this also means the travel of the arm is shorter. Again, ensure that the servo arm is
nowhere near going over-center throughout the entire range of the control system.
Long Arm
Max Linear Travel
A: 3.4”, B: 3.0”, C: 2.6”
Max Force @ 100% Torque
SV32L - A: 18lb, B: 20lb, C: 24lb
SV42L - A: 27lb, B: 31lb, C: 36lb
SV52L - A: 36lb, B: 41lb, C: 48lb
Standard Arm
Max Linear Travel
A: 2.6”, B: 2.2”, C: 1.8”
Max Force @ 100% Torque
SV32 - A: 24lb, B: 29lb, C: 36lb
SV42 - A: 36lb, B: 44lb, C: 55lb
SV52 - A: 48lb, B: 58lb, C: 72lb