Dynon Avionics EFIS-D10 Installation Guide - Manual (Page 8)

EFIS-D10 Installation Manual
EFIS-D10 Installation Guide Doc Num: 100006-000 Rev. C
9/11/2003 Page 8 of 24
Schematic
The following diagram details the external electrical connections for the EFIS-D10. In practice,
not all of connections may be needed. The only required connections to make the EFIS-D10 fully
functional are MS (pin 1), GND (pin 3) and the RS232 PC Communication harness (pins
9,10,22). As mentioned in the Calibration section, a PC is required to perform some of the
calibration and configuration steps.
The connector on the EFIS-D10 is a male D-25 connector. Your harness needs to terminate with
a female D25 connector.