Dynon Avionics Heated AOA/Pitot Probe - Manual (Page 8)

Introduction
1-2 AOA/Pitot Probe and Heated AOA/Pitot Probe Installation Guide Rev. C
To display angle of attack on a Dynon Avionics EFIS unit or SkyView System, only a
Dynon Avionics AOA/Pitot Probe or Heated AOA/Pitot Probe is supported. Using
another manufacturer’s or homemade AOA/Pitot probe may not produce accurate
AOA information.
To ensure accuracy, it is very important that you install the probe correctly and
perform the specified calibration steps. We recommend that you read and
understand this entire manual and the corresponding calibration procedure in
your EFIS unit’s Installation Manual or SkyView System Installation Guide before
proceeding with installation.
The exterior of Dynon Avionics’ AOA/Pitot Probes and Heated AOA/Pitot Probes
exterior are plated. Do not polish the probe – doing so could abrade the finish.
Block diagram of major steps for installation of AOA/Pitot Probe