Crimestopper Security Products RS999 User Manual
Page 19
900 V TRANSMITTER / 999FM TRANSCEIVER CODE LEARNING
Transmitter/Transceiver Code Learning: (Excludes RS901)
Note: Remote Transmitters/Transceivers come pre-programmed from the Factory. When re-learning remotes or
adding remotes, ALL your system’s remote codes must be learned at time of programming!! These systems
allow storage of up to 4 different remote codes in memory.
1. Open hood (ground the Gray hood pin wire if no hood pin is installed.)
2. Turn key to the ON position. (Starting the vehicle is not necessary.)
3. Press Program/Valet button 4 times. After a few seconds, the unit will flash the parking lights exactly 4 times.
4. RS900: Press Button #1 (Lock) of the transmitter to be learned. RS999FM: Both the Lock & Unlock button must be
pressed. You should get 2 light flashes indicating the code-learn. Now the unit is waiting for a 2
nd
code, so repeat
this step as needed with up to 3 additional remotes. The unit will flash the lights in succession after each code
learned for up to 4 codes. (2 flashes for the 2
nd
code, 3 flashes for the 3
rd
code etc.) If all 4 codes are learned, the
unit will automatically exit code learning mode, otherwise turn key OFF and close the hood. (See Diagram Below)
IGN
OFF
WAIT FOR
4 FLASHES
PRESS 4X's
FLASH 2, 3, or 4 X's
(GRAY WIRE GROUNDED)
RS999FM
RS900 V
IGN
OFF
PRESS TOGETHER
START