Wiring: 11-pin connector – Crimestopper Security Products RS999 User Manual
Page 5
TO
IGN 2
MOTOR
ACC
START
CUT
BROWN
YELLOW/BLACK
86
85
MAKE CERTAIN TO CONNECT "BROWN" START OUTPUT WIRE TO
MOTOR SIDE OF ANTI-GRIND/START DISABLE RELAY.
IGN 1
WIRING: 11-PIN CONNECTOR
PIN 4: BROWN: (-) AUX OUTPUT (TRUNK POP)
This output will provide a ground pulse when button #3 (Trunk) on the remote transmitter is pushed to activate a factory
electric trunk release or other optional accessory. System can also be programmed to DISARM/UNLOCK when trunk
pop is activated to prevent unnecessary triggering of Factory Alarm systems. See Programming Options section.
PIN 5: GREEN: (-) START ACTIVATION INPUT (USED FOR RS901 Add-on/Expansion MODEL ONLY)
This wire allows a host alarm Auxiliary Channel Output or Factory Keyless Entry System to activate a Remote Start by
sending a signal to the GREEN wire. A one-second Ground pulse or 3 successive short pulses (when programmed for
OEM interface) will trigger a remote start. See Programming Options for OEM interface.
PIN 6: GRAY: (-) HOOD PIN SWITCH
Connect the Gray wire to a switch that is at ground when the hood is open. If an existing switch is not available, then we
recommend that one must be installed. When this wire is grounded, the remote start is inhibited. If hood is opened on a
remote started engine, the unit will immediately shut the motor off. The unit will not attempt to start if hood is open.
PIN 7: PINK: NEGATIVE or POSITIVE DIESEL GLOW PLUG INPUT (DIESEL VEHICLES ONLY)
Connect Pink wire to indicator circuit that shows a (- or +) Signal while the “WAIT TO START LAMP” is on. When this