CBM America iDP3240 - Manual (Page 96)

— 77 —
ESC J n
[Function] Printing and feeding paper
[Code] <1B>H<4A>H<n>
[Range] 0 n 255
[Outline] Prints the data held in the print buffer and feeds paper by [n
×
basic calculation pitch] inches. The beginning of the line is taken
as the next print start position.
[Caution] The line feed width can be set separately for the STANDARD
and PAGE MODES.
• This command does not affect the line feed width currently
set.
• Fractions resulting from calculation are corrected with the
minimum pitch of the mechanism, and the remainder is
omitted.
• In STANDARD MODE, this command uses the basic calculation
pitch (y) in the paper feed direction.
• In PAGE MODE, this command acts differently depending on
the printing direction and the start point set with ESC T n:
(1) If the start point is specified at the top left or bottom right,
the command uses the basic calculation pitch (y) in the paper
feed direction.
(2) If the start point is specified at the top right or bottom left,
the command uses the basic calculation pitch (x) in a
direction perpendicular to the paper feed direction.
The maximum set table line feed width is 1016 mm (40 inches).
A setting greater than this maximum is trimmed to the
maximum. The beginning of the line is taken as the next print
start position.
[Default] The initial value is not defined.
[Sample Program] Refer to Sample Program and Print Results for ESC 2 on
page 69.