Clarion VMA633 - Manual (Page 3)

P
RECAUTIONS:
This monitor is intended for use in DC 12V, negative ground vehicles.
Do not operate the monitor in ways other than described in this guide, doing so may cause
damage and void the warranty.
Be careful not to run down the car’s battery while using a multimedia system with the engine
stopped. Doing so may damage the vehicle’s battery or the multimedia system.
Do not disassemble or modify monitor. Doing so may damage it and void the warranty.
Keep moisture away from the set. Water and humidity may damage the internal circuitry.
Do not let the monitor become overheated. If the temperature inside the vehicle is high or the
monitor has been exposed to direct sunlight, lower the monitor’s temperature before use. (The
liquid crystal panel operates within a temperature range of –1~45°C (30~113°F).
In extremely cold temperature, the movement of the picture may slow and the picture may
become dark. The monitor will work normally once the temperature increase to its normal
operation range.
Small black or shiny dots may been see inside the liquid crystal panel. These are normal when
manufacturing liquid crystal products.
D
ESCRIPTION OF
B
UTTON
A
ND
C
ONNECTORS:
6.5 INCH WIDE LCD MONITOR
1 2 3 4 5 6
7
8
9
10
11
12
13
1. Power Button 6. Source Controls 11.Speaker -
2. Dimmer Sensor 7. Video Composite Input (White w.Black line)
3. Remote Sensor 8. 2-Pin Molex Power Connector 12.Speaker + (White)
4. Picture Controls 9. IR Serial Remote OUT 13.Dimmer Lead
5. Wide Mode Controls 10. 8-Pin RGB input DIN cable (Orange)
2
VMA633 6.5” TFT LCD Monitor
VMA633
D
ESCRIPTION
B
UT
TONS