Clarion VMA633 - Manual (Page 5)

1. Look over the vehicle for a monitor location. Each vehicle is different and locations
will vary. Make sure the monitor will not interfere with the driver’s safe operation of
vehicle.
2. Once a location has been determined, run the 3.5 mm IR extension, Video Composite
and power Molex connector into the monitor’s mounting location.
3. Plug main cable into the monitor.
4. Run the IR extension, video, and power cables to their respective destinations.
1 RED
2 GREEN
3 BLUE
4 C-SYNC
5 NOT CONNECTED
6 NOT CONNECTED
7 NOT CONNECTED
8 NOT CONNECTED
6.5 INCH WIDE LCD MONITOR
from Composite Video
Video Source Composite In
To lgnition Fuse
+12V
Ground(To Chassis)
To Remote Onput IR Remote Output
from RGB
Video Source
from RGB Output of RGB Input DIN Connector
NAX9500E
speaker(-)
speaker(+)
Dimmer Lead
NAX
VS718
Video Out
1
2
3
4 5
6 7
8
*CCE-001
VMA633
4
RGB Input DIN Configuration
NOTE:
*These CCE-001 adapt IR of NAX
and/or VS718 to VMA633! Never use
IR connection without CCE-001!
VMA633 6.5” TFT LCD Monitor
I
NS
TALLATION