Panasonic NN46240-710 - Manual (Page 134)

4 MPLS L2VPN troubleshooting
Nortel Secure Router 8000 Series
_________ Troubleshooting - VPN
# Reset the PW template:
<PE> reset pw pw-template pwt1
# Display the configuration and find that the peer IP address of the PW does not change:
<PE> display mpls l2vc 100
Total Idp vc : 1
*Client Interface
Session State
AC Status
VC State
VC ID
VC Type
Destination
Local VC Label
Remote VC Label
Control Word
Local VC MTU
Remote VC MTU
Tunnel Policy Name
Traffic Behavior Name
PW Template Name
Create time
UP time
Last change time
0 up 1 down
Atm2/1/0.100
down
up
down
1
atm aal5 sdu
2.2.2.2
119811
0
Disable
1500
0
pwt1
0 days, 0 hours, 1 minutes, 7 seconds
0 days, 0 hours, 0 minutes, 0 seconds
0 days, 0 hours, 1 minutes, 7 seconds
Fault analysis
Some PW attributes can be configured by using the PW template or by using the CLI command.
However, the latter method has the highest priority.
If PW attributes are specified in the CLI, then those specified in the PW template lose effect.
The PW attributes do not change if the
reset pw template and the reset pw vc-id commands are
run.
In this case, you can use the PW template to set PW attributes that need changes. To set this,
perform the following actions:
# Specify the peer IP address in the PW template:
[PE-Atm2/1/0.100] pw-template pwt1
[PE-pw-template-pwtl] peer-address 3.3.3.3
# Apply the template to the PW:
[PE-pw-template-pwtl] int atm 2/1/0.100
[PE-Atm2/1/0.100] mpls l2vc pw-template pwt1 100
# Display the configuration and find that the IP address of the PW peer is unchanged:
[PE-Atm2/1/0.100] display mpls l2vc 100
Total ldp vc : 1 0 up 1 down
*Client Interface
Session State
AC Status
VC State
VC ID
Atm2/1/0.100
down
up
down
100
4-24 Nortel Networks Inc. Issue 5.3 (30 March2009)