Panasonic TELEPHONE ANSWERING MACHING KX-F115 - Manual (Page 21)

Detailed Operation
i " ' How to Turn on the
—\
Speakerphone
V________
(Answer-Back)
___ /
You may screen the room where the unit is installed,
for sound, by turning the speakerphone on remotely.
You can speak with anyone in the room, even if they
can not reach the unit.
DIAL THE
PHONE NO. PUSH CODE NO. (2 digits)
DURING THE OGM
•The speakerphone of your unit will be turned
on.
If you wish to speak with someone in the room;
3 Call to the person to pick up.
When the person lifts the or
^ ^ speaking.
Push
• If no one lifts the handset or pushes the SP-
PHONE button, the speakerphone will turn off
after 30 seconds.
•To turn on the speakerphone further, push the
[e] button again within 10 seconds of the beep.
5 When you have finished, hang up the
■ Before leaving your office, set the SPEAKER
VOLUME control to the position of normal use,
otherwise, the other party may not be able to hear
your voice.
OGM Skip
If you do not want to listen to the outgoing message,
the unit can be switched directly to the incoming
message recording mode.
2 [| MNO
e
1
right after you hear the beeps.
m
Put!) • ^
DIAL THE
PHONE NO. PUSH “O” DURING THE
OGM
2 To record your message, speak clearly
and loudly after hearing a long beep.
■ You can also use this function to call to someone
in a room. However, if the SPEAKER VOLUME
control of the unit is set to a low position, the
person may not be able to hear you through the
built-in speaker.
•
>
z
CO
m
X
z
o
>
o
m
• If a tone telephone is not available, use the optional Panasonic portable automatic dialer (KX-A70).
•In some areas, a remote tone phone may not function, due to telephone line conditions such as tine noise, echo, etc.
•The unit may not respond if the tone telephone produces too short a tone.
-20-