Panasonic RX-DT650 - Manual (Page 12)

Once broadcast stations have been programmed, they can easily be tuned
Up to ten FM and AM stations each can be programmed.
1 2 4
in at the touch of a button on the unit or on the remote control.
4
3*5
Example; Programming FM 88.1 MHz in preset channel 2.
TUNER/B j ^D^^ Press TUNER/BAND to display
“FM” or “AM”.
- TUNING +
TUNING
MEMORY
AM—FM □
{The display changes each time the
button is pressed.)
Press - TUNING + to tune in
the broadcast station.
FM stations can be selected automatically
(see the right).
—
CM
r u
0 0 1
U O . t
^ _______ !!l _______ -
Press TUNING MEMORY.
6 Repeat steps 2 to 5 to program
the other stations.
Selecting FM stations automatically:
Keep pressing - TUNING + until the frequency display starts to change.
A station with good reception is automatically selected and the selection
process then stops.
To stop the selection at any time;
Press - TUNING + again.
The selection may stop without tuning into any station if there is
interference in the vicinity. In such case, tap - TUNING + until a
station's frequency is picked up.
Programming AM stations:
1. Press TUNER/BAND in steps 1 to display AM.
2. Perform steps 2 to 5.
Press V PRESET TUNING a to
display the preset channel in
which the station is to be
programmed.
TUNING
MEMORY
When IPGMj is flashing, press
TUNING MEMORY.