Using the optional ac adaptor, 2 open the terminal door, 3 connect the ac adaptor to the dc in socket – Panasonic DMC-LC43A User Manual
Page 84: Using the ac adaptor
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Technical
use
Using the Optional AC Adaptor
If you use an AC adaptor (optional, DMW-AC2), you can use the camera without
worrying about battery discharge.
[Preparation]
• Check that the power switch is set to [OFF] and the lens is stored.
1 Connect the AC power plug to the AC outlet.
THE SOCKET OUTLET SHALL BE
INSTALLED NEAR THE EQUIPMENT
AND SHALL BE EASILY ACCESSIBLE.
2
Open the terminal door.
3
Connect the AC adaptor to the DC IN socket
• Do not use the AC adaptor other than the optional one (DMW-AC2).
• The camera becomes warm during use. However, this is not a malfunction.
• The battery cannot be charged in the camera with the AC adaptor connected.
• When disconnecting/connecting the AC adaptor with the power switch turned
on using the batteries, the data in the card may be destoroyed or the operation
may be impossible. Be sure to disconnect/connect the AC adaptor after turning
the power switch off.
84