Timer recording (cont’d) – Panasonic NV-F55EA User Manual

Page 36

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Timer Recording (Cont’d)

Transmit the Programming Data

Keep pressing the Transmit Button and confirm that the
programmed data on the Multi-Function Display of the
VTR are as desired.

After releasing the button, the data will continue to be
displayed for about 12 seconds.

• If the transmission was not received correctly, the

“Beep-Beep, Beep-Beep" sound from the VTR will warn
you. In this case, perform transmission again.

•The transmission is possible when the VTR is turned on

but is not in any of the recording or playback operation
modes. It is also possible when the VTR is in the timer

recording standby mode (□ indication is lit).

• If all programme numbers are occupied, the

“Beep-Beep, Beep-Beep" sound from the VTR will warn
you that the programming cannot be made.

•When the Transmit Button is pressed, the VTR will

automatically be put into the timer recording standby
condition and the VTR will be turned off.

For Programming More Than One Timer Recording in
Succession

Repeat the following operation steps 1-3.

1

Trace the “CANCEL" bar code on the Programming

Sheet.

CANCEL

2

Trace the bar codes for “CHANNEL”, “DATE”,

“START TIME”, “END TIME” and “RECORDING”.

3

Confirm that the present time is displayed on the

Multi-Function Display of the VTR, and transmit the
data.
• If the next timer programming data are transmitted

while the previous timer programming data are still
being displayed, the displayed timer recording data
will be cancelled.

Timer Recording from an External Source

For timer recording of signals input from some other AV
equipment via the Audio/Video Input Socket on this VTR,

trace the “ AV ” or “ AV 1 ” bar code in the “CHANNEL”
column.

Note:
The “AV 2” bar code cannot be used with this VTR,

TIMER ON/OFF

After programming a timer recording, the VTR is in the
timer recording standby mode and cannot be used for any
other operation, such as playback. If some other operation

is desired, first trace the “TIMER ON/OFF” bar code and

transmit it to the VTR with the Transmit Button,
To later reset the VTR to the timer recording standby

mode, trace the “TIMER ON/OFF” bar code again and

transmit it with the Transmit Button.

TIMER ON/OFF

B-

r

L

. J

36

Advertising