Panasonic NV-G21 - Manual (Page 26)

DUBBING (COPYING)
AUDIO VIDEO
Preparation
•Press the VTR On/Off Switches to turn both VTRs On.
•Make the connection between the two VTRs as shown
above.
•Make sure that the Edit Switches of both the recording
and playback VTRs (if equipped) are in the “On” position.
Set these switches to “Off” for ordinary use of the VTRs.
^ Place the recorded cassette in the playback VTR and a
blank video cassette with the erasure prevention tab
intact in the recording VTR.
0 Press the Record Button (•) on the recording VTR.
REC*
REC
AUDIO IN VIDEO IN
^ Press the Play Button (►) on the playback VTR.
PLAY
>
O Press the Stop Button (■) on both VTRs to stop the
dubbing.
r
STOP
□
y
•To assure smooth, noiseless cuts when interrupting
the recording, always use the Pause/Still Button
( I I ) .
•To obtain smooth cuts when starting the recording
from the stop mode:
1. Play back the last part of the previously recorded
material to confirm its ending point, and then
press the Pause/Still Button
( I I ) .
2. Press the Record Button (•).
(The VTR is still in the pause mode.)
3. To start recording, press the Pause/Still Button
(II) again.
•The picture quality of a re-recorded tape is not as
good as that of the original.
•Ensure all cables from the Video Input and Audio
Input sockets are disconnected after finishing the
recording. If they remain connected, it is impossible
to record TV programmes.