Panasonic RX-FT560 - Manual (Page 2)

Thank you for purchasing this unit.
For optimum performance, follow these operating instructions carefully.
o|f the set is not used for a long period of time or is
used only from an AC power source, remove all the
batteries to prevent potential damage due to possible
battery leakage.
«Avoid using or placing this unit near sources of heat. Do
not leave it in an automobile exposed to direct sunlight for
a long time with the doors and windows closed as this may
deform the cabinet.
•Avoid cuts, scratches, or poor connections in the AC
power cord, as they may result In possible fire or electric
shock hazard. Also, excessive bending, pulling or splicing
of the cord should be avoided.
•Do not unplug the AC power cord by pulling on the cord.
To do so may cause premature failure or shock hazard.
• Do not operate the set on AC power in a bathroom, as a
potential shock hazard may result.
•When not in use, disconnect the AC power cord from the
AC power outlet.
•The Function Selector switch does not separate entire unit
from mains even If in ‘‘TAPE/ro^’' position.
Max. 40“C
J’l Iftmluilll
WARNING:
TO REDUCE THE RISK OF FIRE OR
ELECTRIC SHOCK, DO NOT EXPOSE
THIS APPLIANCE TO RAIN OR MOIS­
TURE.
CASSETTE TAPES
Use only good-quality tapes up to the length of C-90. Do not
use C-120 tapes with this unit because these tapes can
easily become broken or stretched if not used with extreme
care and may get tangled with the Capstan and Pressure
roller.
OK
Pencil
If the tape loosens, take up the
slack by turning the reel in the
proper directions.
Notes:
•Use normal type of cassette tapes only. If other
tapes are used, you may not obtain optimum
performance.
•Cassettes, both recorded and unrecorded, should
not be stored in locations with high temperature,
high humidity or direct sunlight. Never place a
recorded cassette near a magnetic source, such as
a magnet or a TV set as this may affect tape
performance.
Do not handle, or pull the tape
out of the cassette.
- 2 -