Reloading a recording paper – Panasonic Panafax UF-120 User Manual
Page 61
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Reloading a Recording Paper
Your facsimile machine uses a roll of special recording paper. You can easily load
paper yourself by following the steps below.
1. Open the Receiving Unit (Control Panel) by
pulling the latch button on the right side
panel, and swing the Receiving Unit
forward.
2
*
If there is the used roll inside, lift it out and
set a new roll in its place. Feed the paper
to the Document Feeder cover. Be sure the
direction of the roll is as shown below.
8
3
.
Close the Receiving Unit carefully by press
ing both ends gently until you hear the
cover lock into position.
4
,
Tear the recording paper projecting from
the unit by hand. Remove this cut paper.
61