Electrical connections, Wiring diagram, External amplifier control power lead – Panasonic Removable Front Panel MP3 WMA CD Player/Receiver with CD Changer Control CQ-DP383U User Manual
Page 48: Note, Antenna control lead, Acc power lead, Battery lead, Ground lead
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Electrical Connections
Caution:
• This product is designed to operate with a 12 V
DC, negative ground battery system.
• To prevent damage to the unit, be sure to foiiow
the connection diagram below.
• Remove approximately W' (5 mm) of protective
covering from the ends of the leads before con
necting.
• Do not insert the power connector into the unit
until the wiring is completed.
* Be sure to insulate any exposed wires from a
possible short-circuit from the car chassis.
Bundle all cables and keep cable terminals free
from touching any metal parts.
• Remember, if your car has a drive computer or a
navigation computer, the data of its memory
may be erased when the battery terminals are
disconnected.
□ Wiring Diagram
Antenna
—
External amplifier control power lead
(max. 500 mA)
(BlueMile stripe)
This lead is for connection to the power amplifier.
Note:
• This lead is used for power control when an external power amplifier
is connected. The power supply of a power amplifier will be activated
when turning on the power of this unit.
Antenna control lead
(to motor antenna) (max. 500 mA)
This lead is not intended for use with switch actuated power
antenna.
(Blue)
Note:
• The power antenna extends automailcally
when the AM/FM radio mode is selected.
ACC power lead
To ACC power, -h12VDC.
ACC
(Red)
Battery lead
To the car battery, continuous -i-12 V DC.
BATTERY 15 A
(Yellow)
Ground lead
To a clean, bare metallic part of the car chassis.
(Black)
48
CQ-DP383U