F helpful hint, Tuning procedure, Helpful hint – Panasonic TC-43P15 User Manual
Page 27: I . i
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Tuning Procedure
If the sound is not clear or no
sound
is
produced
on
a
Programme Number Position,
push
the
Volume
Up
or
Down button.
S P R E S E T 1
C H 2
C H S E L E C T
P O S .
S Y S S E L E C T
f lS I fl/M . E .
R U T O T U N E
M R N U R L T U N E
j S O U N D S Y S
5 . S N H
z
H
C O L O U R S Y S
R U T O
F IN E T U N E
S K I P
O F F
You
may
improve
the
Sound quality.
The sound indicator will
change as follows.
4.5MHz <---------- ^ 5.5MHz
i . i
6.5MHz <---------- > 6.0MHz
Note:
When sound volume is too
small to confirm, turn it up
by using the sound volume
button
on
the
remote
control.
Push the “PRE.” (PRESET)
button 4 times.
PRE.
This returns the set to the
normal viewing condition.
f
Helpful Hint
(1) If a clear picture cannot be obtained even when a Broadcast or AV signal is received, refer to the “Colour System
Selection” operation on page 35.
(2) After the Manual tune is finished, push the Programme Number V’ button to confirm the tuning condition for each
Programme Numbers. If some Programme Numbers are unused, it is possible to skip such Programme Numbers.
Please refer to the Programme Number skip operation on page 30.
(3) When using a VCR without video and audio input/output terminals, it is convenient to connect the aerial cable as
indicated in the instruction manual of VCR and to set the designated channel to programme No. “0”. In that case,
perform manual tune after setting the colour system and sound system in advance. Further, in multi-system VCR,
it is more convenient to set the designated channel to several programme Numbers.