Panasonic CF-VFS721 - Manual (Page 7)

The computer does not recognize the
Superdisk Drive Pack.
Is the Superdisk Drive Pack properly mounted
in the multimedia pocket?
The access lamp ((^) does not light. Is the disk set correctly?
Cannot read data from the disk. • Is the disk bent, scratched, or dirty?
• Remove the check mark from [Auto insert notifica­
tion] and [DMA] under [Start]-[Settings]-[Control
Panel]-[System]-[Device Manager]-[Disk drives]-
[MATSHITA LS-120 SLIM****]-[Settings]-[Op-
Cannot eject the disk.
tions].
Is the computer powered on?
If not, power on and press the eject button.
<Use the following procedure if the previous
method failed.>
To remove a disk when the computer is powered off,
insert a sharp object such as a paper clip (made straight)
into the emergency hole. Pushing the object com­
pletely to the end will enable tbe disk to be removed.
However, because there is the possibility that the lock
mechanism of the head carriage may not move, do
not use this metht^^^^^^^^^^^ncies.
Emergency hole
'- aм ММ м :
Ш-л
■""le
Item Description
Operating Voltage Range DC 5 V ± 5 %
Data Transfer Rate 550 to 1000 KB / sec (120 MB mode)
230 (read), 77 (write) KB / sec (2HD mode)
115 (read), 38 (write) KB / sec (2DD mode)
Disk Rotation Rate 1500 rpm
Seek Time (Random seek) 65 ms
Interface Conforms to enhanced IDE (ATAPI) standard
Dimensions (width x depth x height) 133.1 mm
X
147.1 mm x 15.3 mm
(5.24 "x5.79 "xO.60 "}
Weight Approx, 290 g (0.64 lb.}
Operating temperature / humidity
range 5 to 35 “C (41 to 95 °F}* /30 to 80% RH
(no condensation)
15 minutes or more of consecutive disk access, using the SuperDisk Drive Pack between
30 “C and 35 “C, may damage the data on the disk.