Panasonic TOUGHBOOK CF-47 - Manual (Page 14)

starting Up/Shutting Down
Using the Touch Pad
Use the touch pad to move the cursor on the display and perform normal computer operations.
For instructions on how to handle the touch pad, refer to page 15.
The touch pad has the following two modes of operation.
Work Surface
Right Button
Left Button
Microsoft® intelUMouse™ Wheel Mode
(Setting at the time of purchase)
Wheel mode operations (almost identical to
the case of using the Micro.soft® IntclliMouse™
for scroll, zoom, etc., operations) are possible
for Microsoft® wheel function-compatible ap­
plications.
Microsoft® IntelliMouse™ is a mouse-type de­
vice that, in addition to the two conventional
buttons, incorporates a wheel able to rotate
forwards/backwards.
Scrolling Area
j—Scrolling up/down
For the Pan and Auto Scroll function.s, the entire
work .surface of the touch pad can be used for .scroll­
ing.
Original Mode
Only scroll operation is possible for appli­
cations not compatible with the Microsoft®
wheel function.
Even for applications compatible with the
Microsoft® wheel function, there are cases
where only vertical scrolling or only hori­
zontal scrolling is possible in this mode.
Scrolling Area
-¡— Scrolling up/down
Possible when a check mark
is added for [Vertical].
Scrolling side-to-side
Possible when a check mark
^ is added for I Horizontal].
□ : Typical mouse operations use this area.
When no check mark is added for [IntelliMouse Wheel mode], [Horizontal] and [Verti­
cal] of [Scroll Configuration], the entire surface can be used for typical mouse opera­
tions.
note )-
When you are not sure whether an application is compatible with the Microsoft® wheel
function or not, try using both modes. Furthermore, depending on the application, there are
cases where scrolling may not be possible with either mode.
--------------------------------------------------------------------------------------------------------------------^
% Changing the mode of the touch pad
1 Select Q from the taskbar or select [Motion] in [Start] - [Settings] - [Control Panel] -
[Mouse].
2 • To set the Microsoft® IntelliMouse™ Wheel mode
Add the check mark ^ for [lntelliMou.se Wheel mode] of [Scroll Configuration).
• To set the original mode
Delete the check mark for [IntelliMouse Wheel mode] of [Scroll Configuration] and
add the check mark ’Z for IHorizontalj and/or (Vertical).
3 Press [OK].
Handling the Touch Pad
► Do not place any object on the work surface or press down forcefully with sharp-pointed
objects (i.e. nails), hard objects or objects that can leave marks (i.e. pencils and ball point
pen).
► Do not allow things that could dirty the touch pad, such as oil. The cursor may not work
properly in such cases.
t When the touch pad becomes dirty;
Wipe to remove dirty areas by using a dry soft cloth such as gauze or a soft cloth first applied
with detergent diluted with water and then thoroughly wrung.
Do not use benzene or thinner, or disinfectant-type alcohol.
1 4