Panasonic SQ-TC520N - Manual (Page 30)

TROUBLESHOOTING
Is the power cord plugged in correctly? 14
Tray doesn't eject. Is the CD or CD-ROM inserted properly? 18
Disconnect the headphones. 8
Computer doesn't
boot.
Is there a disk in the floppy disk drive?
Is the IDE cable plugged into the expansion card correctly?
Does Pin 1 of the EIDE cable have the proper orientation?
14
CD player doesn't Is the device driver installed correctly? 10-12
respond to computer Is the IDE interface cable connected properly, completely inserted, is
14
commands. Pin 1 connected to pin 1 etc.?
Are you trying to use a CD or CD-ROM that is not compatible with this
machine?
Are you using the appropriate CD or CD-ROM software?
CD or CD-ROM Is the CD or CD-ROM inserted properly? 7, 18
won't play. Is the CD or CD-ROM inserted with the label side up?
Is the CD or CD-ROM scratched, broken, warped or dirty?
Is there condensation on the machine? {If so, leave the machine on for
an hour and try again.)
No sound comes out Is the volume adjusted properly? 8
of headphones. Are the headphones properly connected?
The CD-ROM Have you checked which version of Windows 95 you have?
Changer doesn’t Have you installed SmartCD Manager ver. 3.6 or later?
work correctly in Have you installed the software first?
y
Windows 95. Is the jumper pin setting for DMA OFF terminal correct?
Device driver won’t 1) Existing real mode driver in config. sys
load in Windows 95. 2) IDE controller is not set correctly—check control panel in Windows —
95
NOTE;
When returning the product to the Service Center, please also print out the personal computer’s
AUTOEXEC.BAT and CONFIG.SYS files and send with the product.