Compatible Systems T1-10/100 - Manual (Page 13)

Chapter 2 - Quickstart Instructions 9
Box (under Global/IP Static Routes) to set static routes. OSPF and BGP can only be config-
ured using text-based configuration.
TB: Use configure and set either the RIPVersion keyword or the OSPFEnabled keyword in
the IP WAN 0 (and/or any other port you wish to configure) section. Add static routes and a
default router using the edit config IP Static command.
v Note: Due to the complexity of BGP, configuration parameters for BGP are not given in this
Quickstart. For help with BGP configuration parameters, and other configuration questions,
refer to the Tech Support pages on the Compatible Systems Web site at:
http://www.compatible.com/.
IPX Protocol
Required for IPX
Frame Relay operation requires that the WAN interface be set as a “numbered interface.” This
means that the interface (and thus the Frame Relay network) must have an IPX network
number.
• IPX numbered interface
• IPX network number
CV: Use the IPX Routing: WAN Dialog Box.
TB: Use configure and set the Numbered and Net keywords in the IPX WAN 0 (and/or any
other port you wish to configure) section.
Suggested for IPX
The settings above are all that is generally required for IPX operation over Frame Relay.
AppleTalk Protocol
Required for AppleTalk
Frame Relay operation requires that the WAN interface be set as a “numbered interface.” This
means that the interface (and thus the Frame Relay network) must have an AppleTalk network
number and the interface must have an AppleTalk node number.
• AppleTalk numbered interface
• AppleTalk network number
• AppleTalk node number
• AppleTalk zone name
CV: Use the AppleTalk Routing: WAN Dialog Box.
TB: Use configure and set the Numbered, NetLower, and DefZone keywords in the Apple-
Talk WAN 0 (and/or any other port you wish to configure) section.
Suggested for AppleTalk
You may want to use more meaningful zone names.
CV: Use the AppleTalk Routing: WAN Dialog Box.
TB: Use configure and set keywords in the AppleTalk Phase 2 WAN 0 (and/or any other port
you wish to configure) section.
DECnet Protocol
Required for DECnet
In order to be used, DECnet must be turned on both globally and for a particular port.