Compatible Systems T1-10/100 - Manual (Page 5)

Introduction to the Octal T1-10/100 RIOP 1
Introduction to the Octal T1-10/100 RIOP
The Octal T1-10/100 Routing Input/Output Processor (RIOP), as part of the VSR multigigabit
switching router, allows you to connect a local Ethernet and up to eight remote corporate
networks. Each of the T1 interfaces has a data capacity of 1.544 Mbps, while the Ethernet
interface can operate at either 10 Mbps or 100 Mbps.
This section of the manual contains information specific to the Octal T1-10/100 RIOP. It is
divided into the following sections:
Chapter 1: Network Installation
Here you will find step-by-step instructions on how to physically install the Octal T1-10/100
and connect it to your network.
Chapter 2: Quickstart Configuration
The Quickstart section provides a basic list of parameters that must be entered into the Octal
T1-10/100 for proper operation.
Chapter 3: Shipping Defaults
This section of the manual lists factory defaults for the interfaces.
Chapter 4: LED Patterns
This section of the manual describes the LED indicators for the Octal T1-10/100.