Panasonic AW-CH600 - Manual (Page 8)

QD CAMERA l/F Conneclar
Connect It tn the CAMERA l/F connector on the
pan/tilt head
0 HOUSING l/F Connector
Connect It to the HOUSING l/F connector on the
pan/tilt head
® Defroster
The defroster heater is built in by the process at
vapor deposition It operates when the DEF switch
on the control panel is pressed on, and is turned off
by the thermostatic switch when the temperature
exceeds the preset level
® Side Cover Chain
The chain holds the side cover at about 90° when it
IS opened
Camera Mount
Loosen the camera mount screws, move the cam­
era mount to the round hole position remove the
mount, and fix the mount to the camera
To fix the mount to the camera housing, insert the
camera mounting pin into the rail fixed at the farther
end, and insert the pin into the round hale up front,
making sure that the pm is in line with the hole
Hold the lens as close to the defroster glass surface
as possible, and tighten the mount screws
N d I b - With the lens in the WIDE position, watch the
picture from the camera and determine the
position free of wiper shadow )
® Camera Mount Screws
® Camera Housing Control Board
This beard automatically controls the ON/DFF of the
wiper, fan, rubber heater and defroster with control
signals from the control panel
® LENS l/F Connector
Connect It to the lens control cable (for zoom and
focus control)
0 l/F REMOTE Connector
Connect
It
to the l/F REMOTE connector on the
camera via the camera connecting cable
0 ND/EXT Connector
This connector is used to control the lens ND filter
and extender It is not used if the lens does not
have the ND filter/extender function
Silicon Rubber Heater
This heater is turned on when the internal tempera­
ture of the camera housing falls, provided that the
H/F switch on the control panel is in the ON posi­
tion
-B-