Panasonic AW-CH600 - Manual (Page 9)

CAUTION
Be sure to keep system power (including the
power of the pan/tilL head and AC adapter)
switched oft during installation and connection
F
ix the housing to the pan/tilt head securely so
that It will not be unsteady during pan/tilt or when
the head is still
□ □ not install the camera housing at a place
extremely cold below -SO^C or extremely hot,
over +BD°C tc avoid operation instability
Camera Mounting
Loosen the camera mount screws, move the cam­
era mount tc the round hole position, remove the
mount, and (ix the mount tc the camera
In mounting the camera remember that the mount­
ing screw and spacer may be used cr net depend­
ing on the model
To fix the mount to the camera housing, insert the
camera mounting pm into the rail fixed at the farther
end and insert the pm into the round hcle up front,
making sure that the pin is m line with the hole
Hold the lens as close to the defroster glass surface
as possible, and tighten the mount screws
To use the 33X (3GX) lens, the lens support and
screws (options) are necessary Consult the store
where you purchased the product
Male With the lens in the TELE position watch the
picture from the camera and determine the
position free cf wiper shadow )
After meunting the camera, check that the camera
I S
free of play
Camera AW-EBQO
Install the camera with the camera mounting screw
(9 mm)
-3-