CHEVROLET Tahoe User Manual

Page 155

Advertising
background image

6. Turn the transfer case dial clockwise to

NEUTRAL till it stops and hold it for
10 seconds. Then slowly release the dial to
the four low position. The NEUTRAL light will
come on when the transfer case shift to
NEUTRAL is complete.

7. If the engine is running, verify that the

transmission is in NEUTRAL (N) by shifting the
transmission to REVERSE (R) for one second,
then shift the transmission to DRIVE (D) for
one second.

8. Turn the ignition to ACCESSORY, which will

turn the engine off.

9. Place the transmission shift lever in PARK (P).

10. Release the parking brake prior to moving

the vehicle.

11. Turn the ignition to LOCK.

Shifting Out of NEUTRAL

To shift out of NEUTRAL do the following:

1. Set the parking brake and apply the regular

brake pedal.

2. Shift the transmission to NEUTRAL (N) and

turn the ignition to RUN with the engine off.

3. Turn the transfer case dial to the desired

transfer case shift position (Two-Wheel
Drive High, Four-Wheel Drive High, AUTO).

After the transfer case has shifted out of
NEUTRAL the NEUTRAL light will go out.

4. Release the parking brake prior to moving the

vehicle.

Notice: Shifting the transmission into gear
before the Four-Wheel Drive Low indicator light
has stopped flashing could damage the
transfer case. To help avoid damaging your
vehicle, always wait for the Four-Wheel
Drive Low indicator light to stop flashing
before shifting the transmission into gear.

5. Start the engine and shift the transmission to

the desired position.

Excessively shifting the transfer case into or out of
the different modes may cause the transfer
case to enter the shift protection mode. This will
protect the transfer case from possible damage
and will only allow the transfer case to respond to
one shift per 10 seconds. The transfer case
may stay in this mode for up to three minutes.

155

Advertising
This manual is related to the following products: