Yamaha disklavier YMM Series - Manual (Page 12)

Power Off Procedure
Audio cable (not supplied)
Power On Procedure
Set the MAINS switch to ON.
Press the [STANDBY / ON] button on the front panel of the Control
Unit.
The following message appears on the display.
Turn your sound system on if you will be playing back Ensemble songs.
Your Disklavier is now ready for use.
If you were using a sound system, turn it off.
Press the [STANDBY / ON] button on the Control Unit.
Set the MAINS switch to OFF.
Operating the Disklavier’s MAINS switch is effectively the same as disconnecting the
power cable from an AC wall outlet. So if the Disklavier is used regularly, you only
need to use the [STANDBY / ON] button on the Conti'ol Unit. If the Disklavier is not
going to be used for a long period, set the MAINS switch to OFF.
Note: The [STANDBY / ON] button on the control panel must be switched off
before switching off the MAINS .switch .so that “soft mode”, if used, is
released. If soft mode is not released, the keyboard will become uneven,
and the piano action will be unfit for playing. See “Adjusting the Volume”
on page 24.
When the Disklavier is powered off, wait at least 5 .seconds before powering on again.
Connecting Other Equipment
To connect MIDI instruments to the Disklavier, see Chapter 21 “The Disklavier & MIDI”.
To connect a computer to the Disklavier, .see Chapter 22 “The Disklavier & Computers”.
00
0)
j/j.
n‘
O
T3
n>
QJ
r+
5’
D
in
12 Chapter 3: Setting Up Your Disklavier Power Off Procedure 13