5*s:t¥)li/assembly procedure, S:t¥)li/assembly procedure, I]|eli(7)ljiu#lt/attach the pivot mount – Yamaha CBF-32B/36B User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
»¿
5
*S:T¥)li/ASSEMBLY PROCEDURE
^The following procedures are required if only the stand is purchased.
[i]|Eli(7)lJiU#lt/Attach the Pivot Mount
2. K5AICiiurUS[Hl$E®^12D5^U, T.i'V
3. [51lilii)'K5AICUoi)'D<i;@:E?nrUSC:<h^5iiS^,
1. Loosen the small lug (aligned lug) and remove the head.
2. Remove the mount attached to the drum, and attach the Pivot Mount that is included
with the main drum stand.
3. Before re-attaching the head, make sure that the Pivot Mount is firmly attached to the
drum.
T-
v
-
h
:^7'U
v-t»—^:^•y
hT4®ipifill^Lt-ro
iKAttach the Pivot Mounts to both sides of the drum shell by placing the Pivot Mount section
on the outside and the plate section on the inside of the shell and attaching the securing
the two sections in place with four screws, spring washers and nuts.
Example
< K7AF*3tJ>