Channel Plus 5115BID - Manual (Page 4)

Method Two: Use the power injector to apply power along the Cat
5 or quad wire run. Cut the connecting wire along the run and insert
the power injector. Connect the wires using the color coding. Then
plug the power supply into the power injector.
The green LED in the upper right corner of the channel injector will
be lit showing power is active.
Method Three: Apply power directly at the wall plate.
7
Applying Power and Programming
Step Three
The 5115 series has three different methods for applying power
to the system.
Use only one method for applying power.
Method One: Apply power directly to the channel injector with the
power supply.
The green LED in the upper right corner of the injector will be lit
showing power is active.
(See power length requirements page 8)
6
Power plug
Lower right of
channel injector
© 1999
power supply
power injector
pin 1
blue/white
cut Cat 5 wire
power plug
The green LED in the lower
right corner of the wall plate
and upper right corner of the
channel injector will be lit
showing power is active.
power supply
power plug