Channel Plus 5115BID - Manual (Page 5)

How to Program
Determine which unused channel you want to view your video
source on and program the injector for that channel. There must be
one unused channel both before and after the selected channel to
avoid interference. The new channel will be combined with the exist-
ing channels and appear on all televisions.
To program: For example channel 60
1: Press the button 6 times.
2: Wait for the LED to relight.
3: Press the button 10 more times (pressing 10 times enters “0”).
The injector will now combine the wall plate feed on channel 60 with all other
existing channels from the incoming CATV or antenna.
To program a three digit channel: For example channel 120
1: Press the button 1 time.
2: Wait for the LED to relight.
3: Press the button 2 more times.
4: Wait for the LED to relight.
5: Press the button 10 more times.
Finding Unused Channels
CATV: Determine the highest channel number delivering a picture,
excluding 95-99. Tune the TV up one channel at a time from the last
channel with a picture until finding one channel with no trace of a
picture or interference, just snow.
Antenna: Tune the TV one channel at a time from channel 14-64.
Locate one channel that has no trace of a picture or interference,
just snow.
9
green LED
programming button
Upper right corner on
channel injector
© 1999
Power Length Requirements
Method One
Power Length Requirements
Method Two
Power Length Requirements
Method Three
8
power plug
Up to 300’ of
Cat 5 or quad
wire maximum
power plug
power plug
Up to 300’ of
Cat 5 or quad
wire maximum
Up to 100’ of
Cat 5 or quad
wire maximum
Up to 100’ of
Cat 5 or quad
wire maximum