Tuner, Remote control – Yamaha HTR-5540 User Manual

Page 55

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Tuner

TROUBLESHOOTING

Problem

Cause

Remedy

Refer

to page

FM stereo reception is

noisy.

The characteristics of FM stereo
broadcasts may cause this problem
when the transmitter is too far away or
the antenna input is poor.

Check the antenna connections.
Try using a high-quality directional FM

antenna.

17

Use the manual tuning method.

34

FM

There is distortion, and
clear reception cannot

be obtained even with a
good FM antenna.

There is multipath interference.

Adjust the antenna position to eliminate
multipath interference.

The desired station
cannot be tuned in with
the automatic tuning

method.

The station is too weak.

Use a high-quality directional FM antenna.

17

Use the manual tuning method.

34

Previously preset

stations can no longer

be tuned in.

This unit has been disconnected for a
long period.

Re-store the stations.

35, 36

The desired station
cannot be tuned in with
the automatic tuning

method.

The signal is weak or the antenna
connections are loose.

Tighten the AM loop antenna connections

and orient it for best reception.

17

Use the manual tuning method.

34

AM

There are continuous
crackling and hissing

noises.

Noises result from lightning,
fluorescent lamps, motors, thermostats
and other electrical equipment.

Use an outdoor antenna and a ground wire.

This will help somewhat, but it is difficult to
eliminate all noise.

17

There are buzzing and
whining noises
(especially in the
evening).

A TV set is being used nearby.

Move this unit away from the TV.

Remote control

Problem

Cause

Remedy

Refer to
page

The remote control

does not work nor

function properly.

Wrong distance or angle.

The remote control will function within a

maximum range of 6 m (20 feet) and no more
than 30 degrees off-axis from the front panel.

7

Direct sunlight or lighting (from an
inverter type of fluorescent lamp, etc.) is
striking the remote control sensor of this
unit.

Reposition this unit.

The batteries are weak.

Replace all batteries with new ones.

3

51

Advertising