Panasonic MC-V7305 - Manual (Page 17)

GIÎEANiNGl
":
îk
<S
îî
!>;
æî
S'
î
*..<. v^«;SsSiiiV.
1
. Unplug cord from wall outlet.
DO NOT drip water on cleaner.
2. Clean exterior using a clean, soft cloth that has been dipped in a solution of mild liquid
detergent and water and wrung dry. Wipe dry after cleaning.
3. To reduce static electricity and dust build-up, wipe outer surface of cleaner and attachments.
4.
Wash attachments in warm soapy water, rinse and air dry.
DO NOT clean In dishwasher or
clothes washer.
DO NOT USE ATTACHMENTS IF THEY ARE WET.
A
CAUnON
Attachments used In dirty areas, such as under a refrigerator, should not be used
on other surfaces until they are washed. They could leave marks.
1EMC№ING CLOGS
The hose located on the back of the vacuum cleaner carries the dirt from the nozzle
up to the dust bag. If the hose should become clogged:
1.
Unplug the power cord from the outlet
before checking the airflow passages. Remove
the suction inlet by depressing the two tabs
that secure it to the back of the vacuum, and
check for clogging in this area.
Short
Hose
2. Disconnect the wand from the short hose
and check the hose and wand for clogging.
Plug in the vacuum cleaner and turn it on.
While running the vacuum cleaner with the
wand disconnected, stretch the hose in and
out to remove the clog.
3. If the clog still exists, turn the vacuum
cleaner OFF and unplug the power cord. Turn
the vacuum cleaner over, exposing the under­
side. Remove the lower plate. Remove the
short hose from the housing by lifting it
straight up. Inspect the hose end and clear it
of any obstructions. Reinstall the short hose
and lower plate. See the REMOVING/
INSTALLING THE LOWER PLATE section for
detailed instructions.
- 1 7 -