Connection, Playing (source) vcr, Recording (editing) vcr – Panasonic PVQ-V201 User Manual
Page 20
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Connection
VCR
Connect VIDEO OUT terminal on Playing VCR to VIDEO IN terminal on Recording VCR. To
monitor the dubbing, also connect a TV as shown.
Connect AUDIO OUT terminal on Playing VCR to AUDIO IN terminal on Recording VCR.
In place of a Playing VCR, you can use other equipment, such as a Camcoder.
Simply connect the unit's AudioA/ideo outputs to the Recording VCR.
Playing (Source) VCR
^ Insert pre-recorded tape.
Recording (Editing) VCR
Insert blank tape with record tab.
Press INPUT to set VCR Input mode to LINE for
Video Input. (See “Selecting the Input Mode"
below.)
Press PLAY then PAUSEySLOW
Press REC, then PAUSE/SLOW
immediately to enter PLAY/PAUSE mode, immediately to enter REC/PAUSE mode.
The operation o1 steps 4 and 5 must be done on both
playing and recording VCRs at the same time.
Press PLAY to start dubbing.
Playing VCR starts playback.
Press PAUSE/SLOW to start dubbing.
Recording VCR starts recording.
Press STOP to stop dubbing.
Press STOP to stop dubbing.
To Monitor Dubbing on Your TV
1
Turn your TV on and tune to the Recording
VCR channel (CH3orCH4).
2
Set the VCR/ TV Selector on the Recording
VCR to “VCR."
Dubbing tapes protected with Copy Guard will
have poor quality results.
■ SelectingJnput Mode
Method 1,
”>press INPUT to switch between channel number and
LINE.
Method 2,
->press CH
A
/ ▼ to change display as follows.
.1**2^*3-*—
c
(CABLE) (TV)
—► 125 or 69
D
• “L" lights about 4 sec. on front panel when LINE is
selected.
(^Caution:
unauthorized exchanging and/or copying of copyrighted recordings may be copyright infringement.^
20
For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : [email protected]