Recording will not operate correctly, Remote controller will not work correctly – Panasonic NV-SD1 Series User Manual
Page 18
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Recording will not operate correctly
;.SYMPTOM^''
CAUSE
REMEDY
CHECKED
“EBI” indication
flashes whenever
recording is
attempted.
Erasure prevention tab on
cassette is broken off.
Use a tape with intact erasure prevention tab, or
cover the tab hole with adhesive tape, if the original
recording is no longer required.
Picture is recorded
with noise or blank
screen.
Aerial or aerial lead is
defective.
Check the aerial connection to the VTR. See page 3.
Check your normal TV picture. If there is no picture,
check your aerial.
VTR is not correctly tuned.
Re-tune the VTR. See page 6,
A1 is selected.
Select the required TV programme.
Timer recording
cannot be
performed.
Clock or calendar is
incorrectly set.
Check the clock and calendar. Set to the present
time. (Note this is a 24 hour clock.) See page 5.
Clock is flashing 0:00.
Set the clock to the present time.
Recording start or stop time
settings are incorrect.
Set the recording start and stop times correctly. Try a
short timer recording a few minutes ahead of the
present time to confirm correct operation.
See page 14.
VTR is not set for timer
recording.
Press TIMER REC after programming for timer
recording.
AV external
recordings cannot be
made.
A1 is not selected.
Select A1 (by pressing the A or V buttons).
External AV connections are
incorrect.
Check that connections from the external video and
audio source are correct. See page 13.
Remote controller will not work correctly
SYMPTOM
CAUSE
REMEDY
CHECKED
Remote controller
does not operate
correctly.
Remote controller transmitter
beam is not reaching VTR.
Ensure that remote controller is being pointed at the
VTR and that the transmitter beam is not obstructed.
Distance is too far.
Use remote controller within 7 m of the VTR. If this
range is not possible, replace the batteries.
Batteries are exhausted.
Replace batteries by the AA, UM3 or R6 type
available from your dealer. Note precautions for
replacement on page 9.
Batteries are incorrectly fitted
with (+/-) reversed.
Fit batteries correctly as shown on page 9.
18