Tuning the tv into your vtr, Display symbols – Panasonic NV-SD1 Series User Manual
Page 4
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Tuning the TV into your VTR
The VTR supplies a signal to the TV set via the RF coaxial
cable.
For Australia:
on channel 0 or 1
For New Zealand: on channel 2 or 3
It is possible to view the video picture on your TV in the
same way that you watch TV broadcasts.
If you have connected the VTR to the TV through the
video and audio input sockets then you do not need to
follow the procedure mentioned below. Instead, simply select AV mode on the television.
Operations
Display Symbols
1
OPERATE
Turn on the TV and VTR.
VTR/rV
o
Select the VTR mode.
H
Select the video playback channel which is
not occupied with any TV station.
NV-SD1 A; L (channel 0) or H (channel 1)
NV-SD1EA: L (channel 2) or H (channel 3)
Insert a recorded cassette tape.
•To start the playback, see page 10.
Select a programme number on the TV set
which you wish to use as the video viewing
channel. Then tune in the TV to the picture
from the cassette tape currently playing.
• NV-SD1Aonly
in some areas channel 0 may be used by local TV station.
In this case switch to channel 1.
Stop the playback.
STOP