Clickfree C2N 3.5 - Manual (Page 9)

Clickfree C2N Home Backup (Mac) Backing Up
Unless you stop the countdown by clicking a button, at the end of the countdown period
Clickfree starts the backup.
• If you want to let Clickfree decide what needs to be backed up from where, you
don’t need to do anything further. For details, see “What gets backed up?” on page
6.
• If you want to make changes to how backup is done, click Options and see “How do
I change how Clickfree does backups?” on page 17.
6. During the backup, Clickfree displays a progress window.
When you see the Backup Summary window after the backup is complete, simply click
Close . You’re done!
7. To back up another computer on the same network, connect the USB cable at the back of
the C2N to a USB port of the computer you want to back up. The C2N will install
BackupLink to the computer. Once complete, remove the C2N from the USB port of the
computer and repeat for all other computers you want to back up. BackupLink has now
connected these computers to the C2N via the router and backups will occur
automatically.
8. Leave the C2N connected to any computer on the network that has BackupLink installed
and Clickfree will continue to automatically back up every other computer on the
network that has BackupLink installed.
If you later uninstall the BackupLink (e.g. if you will be running Clickfree on this
computer only), or if you unplug the C2N before the backup is complete (and
therefore BackupLink does not get installed), you must use this procedure to run the
backup each time. BackupLink is only installed automatically after the first backup;
each subsequent backup will prompt you to install it (unless you select “Do not show
this message again”).
Copyright © 2010 Storage Appliance Corporation. 9