Panasonic TC-29GA30R - Manual (Page 26)

1,3 2
□ □□ □ □ □ □
DISPLAY TVMV PRE. V A
Sound System Selection (Different countries use differing systems)
1
PRE
(This function is used oniy in the TV mode, and is not applicable in AV Mode)
When the sound is not clear or no sound is produced on a Programme Number, push the
“PRE.” (PRESET) Button 5 times, setting the Preset Menu to "SOUND SYS”.
Push the Volume Up “+” or Down Button repeatedly until the optimum sound is obtained.
The sound system will change as shown.
4.5MHzO5.5MHzO6.0MHzO6.5MHz Note: These are different sound broad­
cast transmission systems applica­
ble to differing countries.
Push the “PRE.” (PRESET) Button 4 times to return the set to the normal viewing condition.
The selected Sound System is automatically memorised.
PRE?
Colour System Selection (Different countries use differing systems)
1
PRE?
If a clear picture with current colours cannot be obtained when a Broadcast or AV signal is
received, push the “PRE." (PRESET) Button 6 times, setting the Preset Menu to “COLOUR
SYS". In AV mode it is only nesessary to push the “PRE.” (PRESET) button once.
Push the Volume Up or Down Button repeatedly until the optimum image is produced.
The colour system will change as shown.
AUTO PAL^^SECAM
NTSC 3.58 <—---- >NTSC 4.43
Note: PAL, SECAM and NTSC 3.58 are different colour signal broadcast transmission
systems applicable to differing countries. NTSC 4.43 is a trick playback mode used in
special VCR’s to playback NTSC recorded video tapes through PAL television
equipment.
PRE
Push the “PRE.” (PRESET) Button 3 times, (In AV Mode it is only necessary to push the
“PRE.” (PRESET) button once.) to return the set to the normal viewing condition.
The selected Colour System is automatically memorised.