Final installation, Final checks, Precautions – Panasonic CQ-R145U User Manual
Page 20: Installation procedures, Installation guide
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Installation Guide
continued
Motor Antenna
Connect the car motor antenna lead to the blue
motor antenna relay control lead.
Battery
Connect the yellow battery lead to the correct
radio wire or to the battery fuse port on the fuse
block.
Antenna
Connect the antenna by plugging the antenna lead
into the antenna receptacle.
Equipment
Connect any optional equipment such as amplifier,
according to the instructions furnished with the
equipment. Keep about 12 inches (30 cm) of
distance between the speaker cords/amplifier unit
and the antenna/antenna extension cord. Read
the operating and installation instructions for any
equipment you will connect to this unit.
Power
Connect the red power lead to the correct car
radio wire or to the appropriate fuse port on the
fuse block.
If the stereo unit functions properly with all these
connections made, disconnect the wires and
proceed to the final installation.
□ Final Installation
Lead Connections
Connect all wires, making sure that each
connection is insulated and secure. Bundle all
loose wires and fasten them with tape so they
won't fall down later. Now insert the stereo unit
into the mounting collar.
Congratulations! After making a few final checks,
you’re ready to enjoy your new auto stereo
system.
□ Final Checks
1. Make sure that all wires are properly
connected and insulated.
2. Make sure that the stereo unit is securely
held in the mounting collar.
3. Turn on the ignition to check the unit for
proper operation.
If you have difficulties, consult your nearest
authorized professional installer for assistance.
□ Precautions
• When bending the mounting tab of the mounting collar with a screwdriver, be carefull not to injure
your hands and fingers.
• We recommend you to wear gloves for installation work to protect yourself from injuries.
□ Installation Procedures
Note: Disconnect the cable from the negative (-) battery terminal.
1. Secure the Mounting Collar 0,
Insert Mounting Collar® into the car’s dashboard, and bend mounting tabs out with a screwdriver.
20
CQ-R145U