Panasonic OMNIVISION PV-M2737 - Manual (Page 24)

VCR Plus+ Setup
Easy Taping.
VCR Plus+ programming allows you to set most items of a timer recording by simply entering a special code (PlusCode) found in TV
GUIDE magazine as well as the TV listings in selected newspapers. In order for your Combination VCR to do a VCR Plus+ recording, or
a timer recording of cable stations, some setup is required.
At first, choose your
Connection Type.
(Then, follow the instructions under the diagram.)
Cable Box Setup
For Connection Type A (see left) only
Connection Type A
<CABLE BOX -> COMBINATION VCR>
Cable Box
^1« (^'our
Cable/
Antenna
RF Coaxial Cable Back Of
(notsupplied) Combination VCR
Front of
Combination VCR
If your system looks like this, do the foi-
lowing.
1. Compiete the “Cable Box Setup”
section at right.
2. Skip page 25 and go directiy to page
26 for VCR Plus+ Programming.
Connection Type B
<CABLE or ANTENNA COMBINATION VCR>
Back of
Combination VCR
From Antenna
or Cable
Cable/
Antenna
RF Coaxial Cable
{not supplied)
If your system looks like this, do the
following.
1. Skip the “Cable Box Setup” section
at right and turn to page 25.
2. Complete the “VCR Plus+ Channel
Setup” section on page 25.
3. Turn to page 26 for VCR Plus+
Programming.
VCR Plus+ and PlusCode are
trademarks of Gemstar
Development Corporation.
The VCR Plus+ system is
manufactured under license from
Gemstar Development Corporation.
I w
Push MENU to
display the MAIN
MENU.
CH CLOCK EXIT Push A ^ ^ to
select “CH,” and then
push MENU to
display the SET UP CHANNEL screen.
MAIN MENU
VCFT
©
SELECT: A ▼ A ► KEY
SET :MENU KEY
Push 'to select
“CABLE BOX SET
UP,” and then [>to
set.
--- SET UP CHANNEL ---
ANTENNA SYSTEM : CATV
AUTO SET
VCR PIUS+ CH SET UP
SELECT : A V KEY
SET ;► KEY
END :MENU KEY
Push ^ ^to select
“YES” or “NO,” and
then push 0 to set.
Select YES If all
channels are received
via the cable box
(connection "A” at leftL Then, go to step 5.
Select NO If your cable connection “B” at left.
Push MENU to exit and turn to page 25.
ARE YOU USING
A CABLE BOX?
YES
l?!*l
SELECT :A T KEY
SET > KEY
END :MENU KEY
Push A V to select
Cable box output
channel number,
and then push |5^to
enter.
If necessary, refer to your cable
box manual.
If you are using Audio/Video jack
connection for your cable box,
select and set “VIDEO OUT’ as the
output channel.
ENTER CABLE BOX OUTPUT
CHANNEL
EH
SELECT :A ▼ KEY
SET :► KEY
YOUR TV IS RECEIVING
THE OUTPUT OF CABLE BOX
CH 01
This display appears for
5 seconds. (Channel
shown is example only)
Push MENU to exit this mode and then,
push ^ V
<3 E>
to select “EXIT.” Now,
push MENU to exit from the MAIN
MENU.
Go directly to VCR Plus+ Programming
on page 26.
24