Panasonic CT-27S20 - Manual (Page 13)

Control Operation (cant.)
Helpful Hints:
Press the TV Mode Selection button to operate TV
Remote functions, if necessary
Recall Button
- Press the RECALL button to
review
(T) Audio Mode status
@
CH number or Video Input selected
@ Sleep Timer status
( 4) Clock time
© Channel Caption (Station Identifier)
© ©
STEREO
SAP
MONO
^VIDE(^
СНЭ
XYYZ
0
2Э 1-00
© ©
©
R-Tune Button
- Press the R-TUNE (RAPID
TUNE) button to instantly switch between the last two
channels selected (without any On-Screen display
being activated)
CHANNEL New
BEING VIEWED
4
Prass Button
Press Button Again
CHANNELTUNED
DIHEDIATELY BEFORE
The MULTI button can be programmed to operate up
to six (6) Remote function buttons at the same time.
For Example:
TV Power/On, VCR Power/On and Cable
box Power/On (selected brands) can be operated at the
same time with one press of the MULTI button
Procedure
1 First program the Remote for the selected device
Infrared access code Confirm that the Remote
Control IS compatible with the equipment
2 Face the Remote Control transmitter away from all
equipment remote sensors
3 Press and hold the Remote POWER button, then
press and hold the ACTION button down at the
same
time for three seconds (All previous
commands are erased)
PRESS AT THE SAME Л ME
FORTHREE SECONDS
4 After three seconds, let go of the POWER and
ACTION buttons
5 Press the MULTI button (Waiting more than 30
seconds without pressing another button will exit the
programming mode)
6 Press a maximum of six (G) function buttons on the
Remote
Each button you press is equal to one function If six
Remote button functions are entered, all will register
in the MULTI button memory in the sequence
entered When finished, press the MULTI button to
end the program mode
The following is an exampie flow chart of Remote
functions that can be programmed Into the MULTI
button (The VCR Mode button should be
programmed before starting procedure.
Multi Button
PRESS AT THE SAME ЛМЕ
FORTHREE SECONDS PRESS PRESS
PRESS PRESS PRESS TO END
PROGRAM MODE
Now you can turn the TV and VCR ON/OFF at the
same time with one press of the MULTI button
To delete entered functions - Press and hold the
Remote POWER button then press and hold the
ACTION button down at the same time for three
seconds Nowyou can enter from one to six different
Remote functions
NOTE: You can also program the MULTI button to
perform most individual Remote Control button
functions Buttons which continuously perform
a function as long as pressed (Volume
Up/Down, Channel Up/Down, etc) cannot be
programmed Only those buttons which
perform a function when initially pressed
(Power On/Off, Mute, Direct Channel Entry,
etc) can be programmed
- 1 3 -