Removal and replacement procedures, 1 covers, 2 printing mechanism – Panasonic KX-P1150 User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
KX-P1150
4. Removal and Replacement Procedures
For safety and to avoid possible damage to electronic components, the AC line cord must be unplugged before
disassembly.
Platen Knob
Screws
Upper Cabinet
Control Panel Cable
4.1 Covers
Caution: The control panel board is installed on the
upper cabinet. The control panel cable is
attached to connector CN300 on the
control panel board and connector CN204
on the main board.
When lifting off the upper cabinet from the
machine, be careful not to damage the
connectors and control panel cable.
1. Remove the paper stand and smoked plastic
cover.
2. Remove the platen knob.
3. Remove the screws (2) from the upper cabinet.
4. Lift off the upper cabinet.
5. Unplug the control panel cable from connector
(CN204) on the main board.
6. Remove the Upper Cabinet.
4.2 Printing Mechanism
1. Unplug connectors CN201, CN202, CN206 and
CN207.
2. Position the carriage on the right side.
3. Remove the cable cover screw and cover.
4. Unplug the printhead flat cable from connector
(CN203) on the main board.
5. Remove the screws (4) from the chassis.
6. Lift off the printing mechanism.
Note: Use care when removing the cable cover to
avoid damaging the print head flat cable.
CN206
CN201
CN202 Cable Cover Screw
CN207