6 carriage assembly, 7 platen assembly, 8 tractor assembly – Panasonic KX-P1150 User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
KX-P1150
4.6 Carriage Assembly
1. Loosen the idle pulley bracket screw (1) and
release the timing belt from the pulley.
2. Remove the head gap lever screw, and Ground
Wire. Remove the head gap lever.
3. Remove the carriage shaft eccentric cams from
the right and left side frames by turning either
clockwise or counter clockwise.
4. Slide the carriage shaft out from the left side and
remove the carriage shaft.
Note: When installing the carriage assembly and its
shaft, ensure that the head gap is properly
adjusted. (Refer to section 5.1).
4.7 Platen Assembly
1. Release the latches on the ejection roller
assembly.
2. Rotate the ejection roller assembly forward.
3.
Remove the ejection roller assembly by lifting
straight up.
4. Release the latch of the platen bushings from the
left and right side frame. Rotate the bushings
toward the rear of the machine.
5. Slide both platen bushings out of the frame by
pushing them inward.
6. Lift off the platen assembly.
Tractor Drive
Tractor Drive
4.8 Tractor Assembly
1. Release the tractor guide shaft from the left and
right side frame by pushing the iatches.
2. Release the latches of the left and right tractor
drive shaft bushings.
3. Lift off the tractor assembly.