Major operating controls and their functions – Panasonic WVCF20 User Manual
Page 4
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
MAJOR OPERATING CONTROLS AND THEIR FUNCTIONS
®(|)(S)0
1. AGC ON/OFF Switch (AGC ON/OFF)
This switch is used to select the gain of the video
amplifier as follows.
ON :
The lens iris is fully operated at low light
shooting, a clear picture is obtained by
automatic increase of the gain.
OFF : A natural and low-noise picture is obtained
under a low light condition.
Note : This switch is preset to the ON position at
the factory.
2. Back Light On/OH Switch (BLC ON/OFF)
When back light affects the picture, set this switch
to ON position for a clear picture. See page 4 for
more details.
3. Picture Detail Selection Switch
(PICTURE SHARP/SOFT)
This switch is used to select the sharpness of the
picture.
SHARP : The sharp picture is obtained,
SOFT : The soft picture is obtained.
Notes ; 1 .When connecting the WJ-450 Color Quad
Unit to this camera, set this switch to the
SOFT position.
2.This switch is preset to the SHARP
position at the factory.
4. Microphone On/OH Switch
(MIC ON/OFF)
By setting this switch to the ON position, the audio
function can be obtained.
5. Audio Control (AUDIO, MAX/MIN)
The audio level can be adjusted by turning this
control.
This is preset to the MAX position at the factory.
Camera Fixing Angle
6. Auto Light Control (ALC, H / L)
This control should be used only for shooting the
object in unusual lighting condition.
Do not adjust this control except the above condi
tion.
Note : To use this control, be sure to set the Back
Light On / Off Switch (2) to the OFF posi
tion,
7. Video Output Jack (VIDEO OUT)
This jack is used to adjust the angular field of view
or focus while observing the picture on the moni
tor.
-3-