Crimestopper Security Products CS-2000DP-TW2 - Manual (Page 9)

9
TRANSMITTER PROGRAMMING
NOTE: All transmitters must be learned at the time of programming. This system can learn up to 4 remotes.
1. Turn key to the ON position and press program button 4 times.
2. After a short delay, the unit will flash the parking lights 4 times, Siren 4 times, Horn 4 times and status
LED will be on solid.
3. Press the Button #1 (Lock) AND Button #2 (Unlock) together on the remote you wish to program.
4. You should get 2 light flashes, 2 siren chirps and 2 horn honks (optional) indicating the unit is waiting for
the second code to learn. Press button #1 and #2 together of a second transmitter, the unit will flash 3
times, 3 siren chirps and 3 horn honks. Press the lock and unlock button on a 3
rd or 4 th transmitter for up
to 4 total. Note: The unit will not flash the lights when learning the 4 th code. Turn key off to exit
programming mode.
IGN
OFF
WAIT FOR
4 FLASHES
PRESS 4X's
FLASH 2, 3, or 4 X's
IGN
OFF
PRESS LOCK & UNLOCK
LIGHTS
SLNT
CrimeStopper
AUX
4 HONKS
4 CHIRPS
2 VEHICLE TRANSMITTER PROGRAMMING
PROGRAMMING SECOND VEHICLE:
See diagram on page 14 on how to use your remote for vehicle #2 operation. To set up your remote, follow
the “Transmitter Programming” steps 1 and 2 (above) In step #3 press the side button on YOUR remote first,
for 2-way press and hold for side button until the “2” Icon show on the remote, then press the Lock and Unlock
button. Your lights should flash indicating the remote is programming. Turn key off to exit programming
mode. Your vehicle should now be programmed for the second vehicle.
NOTE: Your original transmitters must be learned at the time of programming for second vehicle. This system
can learn up to 4 remotes.