Panasonic VideoCipher II Integrated Satellite Receiver/Positioner/Descrambler CRD-4500 - Manual (Page 16)

PROGRAMMING AND OPERATIONS
1. General Information
The CRD-4500 is designed for automatic operation and simplified installation.
Pre-stored in the memory are the names, relative locations, format and frequency band of over 20 satellites with provisions
for storing 10 new satellites when they are launched into orbit.
The set-up mode is accomplishd using the remote controller with no programming controls located on the receiver. After Set-up,
it is extremely simple to change various settings from the remote controller without resorting to the set-up mode. AFC ON or
OFF, video fine tune, audio tuning, audio bandwidth, antenna fine positioning may all be changed from the remote controller
and are automatically stored in memory on a per-channel basis after adjustment.
Satellite selection, channel selection, and audio tuning may be done either by direct access using the 10 number buttons, or
by using the appropriate slew controls.
2. Single Satellite Operation with Fixed Antenna
■ Indication with [_
1. Program Menu
Press l~PFIG I.
^ means button on remote controller and front panel of the receiver. •
• Set-up menu will be displayed unless unit has
been previously programmed. [Fig. 1]
1 SET UP END
2 SELECT DUAL FEED
3 CHANGE WEST LIMIT
4 CHANGE EAST LIMIT
5 ALL MEMORY CLEAR
2. Clear Memory
Press I 5 |.
If unit has been programmed display will show
as [Fig. 2].
Press r~1 I then f PRC I.
• All Memory Clear, then press I 9 I | 1 |
I ENTER~~| within 5 seconds.
[Fig-1]
3. Displays
• See [Fig. 3].
SET UP
NOT YET INITIALIZED
ISET WEST LIMITÒ
ANTENNA POS. 5000
(Fig. 3]
- 1 5 -