Panasonic VideoCipher II Integrated Satellite Receiver/Positioner/Descrambler CRD-4500 - Manual (Page 28)

DIAGNOSTICS
Error Indication (Error is indicated by a flashing message)
No. ON SCREEN CAUSES METHODS OF CORRECTION
(D ERROR-2
When trying to enter the same satellite name/
No. into memory at more than one satellite pos­
itions.
Press 1 ENTER | to release the error. The
satellite is stored at the position selected later.
(D ERROR-3
When trying to enter more than two satellite into
memory at one single satellite positions.
Press 1 ENTER I to release the error. The
priority is given to the name of the satellite
selected later and stored accordingly.
(D ERROR-6
When feedback pulses are not being received.
A.
When the actuator is fully extended or
retrected in the initialize mode or in the
manual mode.
B. When the actuator is not correctly con­
nected with CRD-4500P or the connection
is broken, (no pulse being received)
Press ( EAST |/1 WEST 1 to move the
antenna position slightly in the reverse direc­
tion.
Check that antenna is not into a stop, or that
cable connections to actuator are secure.
®
ERROR-8
“ERROR-2” and “ERROR-3” occurred simul­
taneously. (The same satellite name was tried
to be stored at the same antenna position.)
Press 1 CANCEL 1.
This information has been already stored.
(D ERROR-!
Memory error Turn the power off and Call your dealer.
®
THERMAL OVER
LOAD
If the internal temperature (CRD-4500P)
increases and the thermal protective circuit
(Disable circuit) functions, the unit will not be
operative.
Turn unit OFF to allow to cool. (Wait approx.
10 min. to operate)
Check actuator and antenna for free move­
ment.
- 2 7 -