Panasonic RX-DT670 - Manual (Page 18)

RECORDING (0eck1)
■ Edit pause recording
(Pauses disc play at the end of side A during edit recording)
The edit pause function will prevent recording part of one
track on side A and the rest of the track on side B. For
example, when recording on a 46 min, tape, tracks recorded
on side A and B are not to exceed 23 min. each. (The unit
displays the total time of the tracks programmed.) The unit
will stop recording between sides A and B to allow you to
change tape sides.
The edit pause function cannot be used together with CD
repeat play.
This function does not operate during the tape playback
mode.
Before operation:
Use normal type of cassette tape only.
Check that the tape’s record prevention tabs are intact.
Take up the leader tape in advance.
1. Press the operation switch to turn on the unit.
2. Press the “CD" button of the Kjnction select buttons.
3. Press the CD open/close button to load the CD. Press
the CD open/close button to close the disc tray.
4. Press the stop/eject button of the deck 1 to insert the
recording tape, then close the cover.
5. Press one of the skip/search buttons to specify the
desired track to record on side A, then press the
memory/recali button.
The program indicator will appear and total pla^ng time
will be displayed.
"—;—'' appears on the display when track no. 21 and
above have been programmed.
Program indicator Total playing time
6. Repeat the step 5 for as long as the recording time on
one side of the tape is not exceeded.
Try reserving one more track to see whether it will fit in.
If it exceeds the recording time on one side of the tape,
press the stop/clear button to cancel the track reserved
last.
f D D D
Í
IMUl
J C C
• fC
7. Press the edit pause button (the pause indicator will
appear), and then press the memory/recali button.
Pause indicator
8. Press one of the skip/search buttons to specify the
desired track to record on side B, then press the
memory/recali button.
The total time for the tracks to be recorded on side B of
the tape is displayed next.
Repeat this step as long as the recording time on one
side of the tape is not exceeded.
9. Press the record button of the Deck 1.
The disc play will begin in selected sequence, and
recording will begin. The CD player is automatically set
to the pause mode when the tracks resenred on tape
side A have been played through. The tape continues in
the recording mode (although no sound is recorded)
until its end.
tn nn /
lU
IPflUl
U‘U 1
10, Press the stop/eject button to turn over the tape, and
then press the record button.
A non-reoorded passage of about 13 seconds will be
automatically created. Then, the disc play of the tracks
resenred on tape side B will start and recording will
continue.
•To stop the recording
Press the stop/eject button of deck 1 and the stop/clear
button of the CD section.
•Synchro etart function
This unit is provided with a synchro-start function which
starts disc play when the record button is pressed.
18