Panasonic CW-C240SR - Manual (Page 4)

CW-C200SR, CW-C240SR (Cooling Only)
2. open the
cover.
1. Power Supply
Set the Main Control Knob to the OFF
position; confirnn that the Power Supply
Cord is connected to a proper AC outlet.
<240-220V, 50Hz>
Recommended
Use ihe air conditioner
under the following
conditions;
• When humidity does not exceed 90% and
room temperature is above 21 '"C.
Continuous operation at over 90% humidity
may create condensation and waterdrops on
the intake and outlet vents.
3
. Main Control Knob
Set to either LOW COOL or HIGH COOL as
required. (FAN setting operates the fan only.)
Caution; if the Main Control Knob is turned off
or changed to a fan setting from a cooling
operation setting, WAIT at least 3 minutes
before resetting to a cooling operation.
4
. Thermostat Control Knob
Set the Thermostat Control Knob at the desired
setting. (Usually “6 ~ T is a recommended
setting position.) If the room temperature is
unsatisfactory after a reasonable amount of
time, turn the control knob clockwise to cool the
room more. Or anti-clockwise to cool the room
less.
• When the Thermostat Control knob is set to
“10”, moisture may freeze onto the coils and
prevent effective cooling. If this happens, turn
the knob to High Fan, and the thermostat
control anti-clockwise. This will quickly defrost
the cooling coil so that normal cooling can be
resumed.
5
. Air Swing Switch
(Airflow direction adjustment
Side-to-Side)
For fixed side-to-side air direction, set the Air
Swing Switch to “ON” until the desired air
direction is obtained, then move It to “OFF”.
For continuous side-to-side air circulation, set
the Air Swing Switch to “ON” and leave it there.
- 3 -