Panasonic CW-C240SR - Manual (Page 6)

CW-A200SR, CW-A240SR (Cooling And Heating)
1. Power Supply
Set the Main Control Knob to the OFF
position; confirm that the Power Supply
Cord is connected to a proper AC outlet.
<240-220V, 5QHz>______________ __
Recommendeci
Use the air conditioner
under the following
conditions:
• When humidity does not exceed 90% and
room temperature is above 21 °C,
Continuous operation at over 90% humidity
may create condensation and waterdrops on
the intake and outlet vents.
2
. Open the
cover.
3
. Main Control Knob
Set to either LOW COOL, HIGH COOL, LOW
HEAT or HIGH HEAT. (Fan permits fan
operation without cooling or heating)
* Caution: If the Main Control Knob is turned
off or turned to a fan only setting from a
cooling operation setting, WAIT at least 3
minutes before resetting to a cooling or
heating operation._______________________
J
4
. Thermostat Control Knob
Set the Thermostat Control Knob to the desired
setting. (Usually “4 - 5” is a recommended
setting for heating, and “6 ^ 7” for cooling.) If the
room temperature is unsatisfactory after a
reasonable amount of time, turn the control
knob anticlockwise to make the room warmer,
or clockwise to make the room cooler.
• When the Thermostat Control Knob is set to
“10”, moisture may freeze onto the colls and
prevent effective cooling. If this happens, turn
the Main Control Knob to FAN, and turn the
Thermostat Control Knob anticlockwise. This
will quickly defrost the cooling coil and allow
normal cooling.
5
. Air Swing Switch
(Airfiow direction adjustment
Side-to-Side)
For fixed side-to-side air direction, set the Air
Swing Switch to “ON” until the desired air
direction is obtained, then move it to “OFF”.
For continuous side-to-side air circulation, set
the Air Swing Switch to “ON” and leave it there.
- 5 -